An extended test comparing signals received in Florida from three nearby stations in Australia was conducted 21/12/13, a low elevation path of more than 14,000km.
The A/B comparisons were performed on statistics gathered from the W4HBK grabber, in this case measurements of the noise and each of two transmissions of 1min of steady carrier every 5min over a half hour.
This article describes measurement of an Icom IC-7000 current consumption during SSB telephony transmission.
The capture is of an IC7000 running 100W PEP with compression off. I have read copy as loudly and consistently as I could with barely a breath, so it is an overestimate of current consumption. There was small ALC deflection, but not so much as to effectively provide compression. Compression will draw higher current, depending on the level of compression. Note too, that like many Icom radios, the IC7000 draws a relatively high current key down with no audio (4.5A here).
