A reader of my article End fed wires – new hams love ‘em asked about the performance of the matching transformer described at (Osborne 2014). (Osborne 2014) gives the transformer design above using a FT82-43 ferrite toroid with three turns on the primary. The concept is to adjust the antenna length and C1 for a … Continue reading End fed wires – another matching case study
A lot of radios are made today to use an electret microphone which has a higher output than common dynamic capsules and may require a preamp to comfortably obtain sufficient audio. This article describes a microphone + preamp intended as a drop in replacement for an electret capsule. An electret capsule contains an integral FET … Continue reading A simple preamp for dynamic capsules to suit radios using electret microphones
Hams impoverished for space to erect a ‘full size’ antenna for HF pursue a range of options and end fed wires figure highly. New hams who heard the maxim that ‘any antenna is better than no antenna at all’ will try to use bed frames, window frames, balcony railings, anything metallic to get on air. … Continue reading End fed wires – new hams love ’em
ON9CD (Vandonselaar 2002) gives an expose on baluns for Hams. Above is the first diagram he gives in support of his explanation. Last update: 19th August, 2014, 2:21 PM
Multi band antennas are compromises more so than most mono-band antennas, and part of that compromise is lower efficiency. Often the lower efficiency aspect is accepted without understanding. Last update: 21st February, 2016, 5:16 PM
This is a project to design and build a Guanella 1:1 (current) balun suited for up to 100W on HF with wire antennas and an ATU. For use with a tuner, the most important design criteria are: high voltage withstand; high common mode impedance; power handling. Last update: 11th March, 2024, 7:03 AM
Second part in the series… Design / build project: Guanella 1:1 ‘tuner balun’ for HF – #1 Design / build project: Guanella 1:1 ‘tuner balun’ for HF – #2 Design / build project: Guanella 1:1 ‘tuner balun for HF’ – #3 Design / build project: Guanella 1:1 ‘tuner balun for HF’ – #4 Design / … Continue reading Design / build project: Guanella 1:1 ‘tuner balun’ for HF – #2
This is a project to design and build a Guanella 1:1 (current) balun for use on HF with wire antennas and an ATU. First part in the series… Design / build project: Guanella 1:1 ‘tuner balun’ for HF – #1 Design / build project: Guanella 1:1 ‘tuner balun’ for HF – #2 Design / build … Continue reading Design / build project: Guanella 1:1 ‘tuner balun’ for HF – #1
Under the heading “Wind your own balun “, the WIA’s “Your entry into amateur radio” 2nd ed (The Foundation licence manual) gives advice to newcomers on constructing a 4:1 Guanella balun, a current balun. Last update: 30th March, 2020, 8:23 AM