Graphic demonstration of loss under standing waves

Standing waves change the distribution of voltage and current on a transmission line, and that results in a change in attenuation from that published for a matched load (ie Zl=Zo).

There are many formulas given in various places for calculating the loss under mismatch, almost all of them depend on either ρ (the magnitude of the complex reflection coefficient Γ) or VSWR. Since these are simply related (VSWR=(1+ρ)/(1-ρ)), they have the same dependency. In fact, there is not enough information in ρ (or VSWR) to calculate loss exactly, so they are approximations with underlying assumptions that are rarely exposed.

This article compares the calculation using two common formulas which related loss under mismatch with Matched Line Loss (MLL) with the exact solution using lengths of RG58 terminated with two different VSWR=10 loads at a range of frequencies from 1-30MHz.

Smith

(Smith 1995) discusses estimating line loss using his Smith chart and gives a formula for a Standing Wave Loss Factor subject to some stated conditions:

If a waveguide is one or more wavelengths long, the average increase in dissipative loss due to standing waves in the region extending plus or minus a half wavelength from the point of observation may be expressed as a coefficient or factor of the one-way transmission loss per unit length.

Loss ratio, mismatched/matched=(1+S^2)/(2S)

Rearranging to make mismatched the subject:

TotalLoss (dB)=(1+VSWR^2)/(2*VSWR)*MLL

ARRL

Screenshot - 20_12_2015 , 11_47_04 AM

Since VSWR is more likely to be known, the expansion of Sraw's Eq 16 in terms of VSWR is:

TotalLoss (dB)=10*log(((10^(MLL/10))^2-((VSWR-1)/(VSWR+1))^2)/((10^(MLL/10)) *(1-((VSWR-1)/(VSWR+1))^2))

The formula in these terms is a lot more complicated to enter accurately into a hand calculator, spreadsheet cell, or to calculate with a slide rule.

Comparison with exact loss

 

Clip 080
Fig 1.

Above is a comparison of the two approximations with the exact solution and MLL for 5m of line and Zl=500+j0Ω, VSWR=10.

 

Clip 081
Fig 2.

Above is a comparison of the two approximations with the exact solution and MLL for 5m of line and Zl=5+j0Ω, VSWR=10.

Clip 082

Above is a comparison of the two approximations with the exact solution and MLL for 50m of line and Zl=5+j0Ω, VSWR=10.

A real world example

(Austin 2014) gives a simple analysis of his ZS6BKW antenna described at (Austin 1987), including a table of expected driving point impedances for the dipole itself and table (Table 1) of expected transmission line losses for the transformation line section.

Screenshot - 20_12_2015 , 12_30_01 PM

Above is a table derived from Austin's Table 1 with the addition of loss calculations using ARRL and Smith formulas. Austin used W9CF's line loss calculator which give the exact loss. If we ignore the3.5MHz case, the RMS error is about the same, if we included the 3.5MHz case ignoring ARRL's VSWR restriction (yielding 0.984dB), Smith's RMS error is about 30% of ARRL's.

Conclusions

Some key points to note:

  1. at the very left end of Fig 1, exact loss is less than MLL, so the notion of “additional loss due to VSWR” is misleading;
  2. Fig 1 and Fig 2 are very different though they are both for VSWR=10 loads, clearly there is more at play than simply VSWR (or ρ);
  3. though it is often implied that the ARRL formulas is exact, it clearly is not and is a poorer approximation than the simpler Smith formula for the examples used here;
  4. the ARRL formula in terms of VSWR is quite complicated and a challenge to enter accurately into any calculator, it is impractical when Smith's is easier to use and tends to be more accurate;
  5. the Smith and ARRL formulas are only approximations (even if not declared in the case of ARRL), and probably not very good ones if you have a real need to understand the true loss under standing waves; and
  6. be discerning in your selection of calculator tools, understand the accuracy you might expect from them, validate the results.

References / links

  • Austin, B. Apr 2014. Highs and lows of the ZS6BKW In RADCOM, April 2014, pp. 80, 81.
  • ———. 1987. An HF multiband wire antenna for single-hop point-to-point applications In Journal of the Institution of Electronic and Radio Engineers, 57, 4, 1987, pp167-173. http://www.mpoweruk.com/papers/GSRV_theory.pdf (accessed 21/12/2005.)
  • Smith, P. 1995. Electronic applications of the Smith chart 2nd ed. Noble Publishing Tucker.
  • Straw, Dean ed. 2007. The ARRL Antenna Book. 21st ed. Newington: ARRL.  Ch24.