Loss of ladder line: copper vs CCS (DXE-LL300-1C)

DXE sell a nominal 300Ω ladder line, DX Engineering 300-ohm Ladder Line DXE-LL300-1C, and to their credit they give measured matched line loss (MLL) figures.

Let’s start by assuming that the offered data is credible, let’s take it at face value.

They make the common ham mistake of writing loss figures as -ve dB where in fact by definition they are +ve (MLL=10*log(Pin/Pout)).

The line is described as 19 strand #18 (1mm) CCS and the line has velocity factor (vf) 0.88 and Z0 of 272Ω.

Let us calculate using TWLLC the loss at 2MHz of a similar line but using pure solid copper conductor with same conductor diameter, vf and Z0. We will assume dielectric loss is negligible at 2MHz

Parameters
Conductivity 5.800e+7 S/m
Rel permeability 1.000
Diameter 0.00100 m
Spacing 0.00650 m
Velocity factor 0.880
Loss tangent 0.000e+0
Frequency 2.000 MHz
Twist rate 0 t/m
Length 30.480 m
Results
Z0 272.69-j2.59 Ω
Velocity Factor 0.8800
Length 83.18 °, 0.231 λ, 30.4800 m, 1.155e+5 ps
Line Loss (matched) 0.121 dB

Spacing has been adjusted to obtain Z0.

At 2MHz MLL of a copper line is 0.121dB as against 0.32dB measured for the stranded CCS line.

At 50MHz there is little difference, the CCS line is copper like in its measured loss.

The difference is almost certainly attributable to CCS and stranding. The copper cladding on the very thin strands is way less than skin depth at lower frequencies, effective RF resistance is higher than that of a solid copper conductor.

You might regard that the difference is tenths of a dB and insignificant, but this line is almost always used at high VSWR and the difference between the two lines is likely to be significant.

But is the measured data credible?

If we take the measured data and fit a model that matched line loss is per unit length of line (m) is:

\(MLL=(k_1 \sqrt f + k_2 f)l\)
Where Loss = loss per unit length
f = frequency
k1 = constant
k2 = constant
l = length

Such a model is usually a good fit for practical transmission lines where skin effect is well developed, and dielectric loss is proportional to frequency. A solution for k1 and k2 for least squares error has been found for the DXE published data.

Above is a plot of the measured data and the model. The issue that arises in that the value for k2 is significantly negative, and we ought to expect it is positive and smaller than k2 at these frequencies.

We might expect and excuse some departure from the model at frequencies below 5MHz due to the copper clad steel conductors.

If we compare loss at 30MHz to 10MHz, we would expect it to increase by a factor of 3^0.5=1.73 but it increases by 1.37. This is well above frequencies where CCS effects would show, and well below frequencies where dielectric loss is significant, so it is somewhat surprising that the measured ratio departs so much.

So, the poor fit raises some questions about the validity of the measurement data.