Ground effects on small transmitting loop efficiency

This article explores the radiation efficiency of a small transmitting loop (STL) using a set of NEC-4 models of a 3.14m perimeter loop on 7MHz at varying heights above ‘average' ground.

Radiation efficiency means PowerRadiated/PowerInput.

PowerRadiated is found by summing the power in the far field in 1° increments using NEC. PowerInput is determined from excitation and calculated input impedance.

The example loop is an octagon of 20mm diameter copper, 1m across the sides of the loop. Copper loss is included, a lossless capacitor is used to resonate the loop. A real world loop would be less efficient.

Clip 242

Above is a plot of radiation efficiency vs height of the loop centre. Note the periodic variation, minima are at approximately odd quarter wavelengths in height.

Clip 243

Above is a plot of elements of the feed point resistance. Feed point resistance has been dissected into three elements:

  • Rcond: RF resistance of the loop conductor;
  • Rrad: equivalent resistance that give rise to the radiated power;
  • Rgnd: equivalent resistance that consumes the power not accounted for above.

Rcond is approximately constant, which is to be expected, and it dominated feed point R. It represents RF energy converted to heat in the conductors.

Rrad varies with height, a result of the changing antenna pattern due to reflections from the ground. Because Rcond+Rgnd>>Rrad, changes in Rrad roll up into changes in radiation efficiency.

Rgnd varies cyclically above 6m, but rises rapidly below about 6m. It represents RF energy converted to heat in the soil.

Clip 245

Above is a plot of antenna Q vs height. Remember that this is a model of an antenna with lossless tuning C, real life maximum Q might be well less than half of that shows depending on the capacitor.

Clip 246

Above, the bandwidth plot derived from Q. Again, loss in the tuning cap etc will increase the bandwidth above that shown. Many hams brag about wide bandwidth, it is probably achieved by loss rather than radiation resistance.

The plots are for a specific scenario, and is dependent on frequency, ground type, loop physics.

To some extent, the gain in specific directions may be more important than overall radiation efficiency.

Clip 239

 

The chart above shows the pattern of a half wave dipole at 10m height, and the loop at 1, 3, 5, and 10m height. The gain at elevations below 20° doesn't vary much, the greatest effect is on the gain at the zenith. The gain is much less than a half wave dipole in most directions.

Interestingly, there does not appear much performance disadvantage at low elevation angles in locating the loop quite close to ground.

Conclusions

There is a complicated interaction between Rcond, Rrad and Rgnd that is dependent on the loop,  height and ground parameters.

It is unlikely that simple calculators or design tools take this effect into account at low heights.