Baluns – Rule 500

There is a common Rule of Thumb that to be effective, the magnitude of common mode impedance of a Guanella current balun in an antenna system should be at least 500Ω (Reisert 1978).

This article proposes a possible origin for this thinking, and discusses the validity of the underlying model.

The thinking

Screenshot - 14_05_2014 , 08_36_06Above is a model  (Lewallyn 1995) proposes for a Guanella 1:1 balun using a coil of coaxial line to wind the choke, and goes on to give some equations for analysis of the balun in the context of the following model.

Screenshot - 14_05_2014 , 08_31_33Above is a figure from Lewallyn that captures a very simple linear circuit model that is often used in thinking about a balun in an antenna system.

A little massaging of the numbers shows that if:

  • the coax Zo=50Ω; and
  • Z1=Z2=50/2Ω; and
  • magnitude of Zw is at least 500Ω; then

Insertion VSWR will be no worse than about 1.1.

That sounds like a good objective, designing for Insertion VSWR in a matched system.

Note, that says nothing about its behaviour for other than the case Z1=Z2=50/2Ω (with the centre grounded), nor for the effectiveness in reducing common mode current (its principal function).

Errors

A problem in applying the model to an antenna system is that the model assumes all interconnections are electrically short (ie no significant transmission line effects) and the two GND points are the same point (ie that there is not potential difference between them due to the current that flows between them.

Lewallyn states these restrictions:

A very important point is that the two places labeled “GND” are THE SAME POINT. If Z1 and Z2 represent an antenna or antenna/feedline, the path back to the balun input must be included in values Z1 and Z2. Or, to put it another way, Z1 is the impedance measured between terminals c and b, and Z2 the impedance between d and b, with the balun disconnected.

The above conditions are unlikely to apply in a practical antenna system, so models based on them are unlikely to be valid, and conclusions based on those models are unlikely to be valid.

A further problem is that real antenna systems are unlikely to be accurately represented by Z1=Z2=50/2Ω.

An NEC-4 model of a “Rule 500” balun

Clip 208

Above is the model geometry of a sloping dipole in NEC. The vertical conductor models the common mode current path of a coaxial feed, the blue square near the top is a balun modelled as a load of 5+j500Ω. The red circle is the source exciting the model. This is a classic way of modelling a coax fed dipole.

The model solution shows the magnitude of current on conductors. The figure shows there is substantial common mode current on the feed line, the “Rule 500” balun was not effective in substantially reducing common mode current.

References

  • Duffy, O. 2010. Baluns in antenna systems. VK1OD.net.
  • Lewallyn, R. Nov 1995. The 1:1 Current Balun: http://eznec.com/misc/ibalun.txt (accessed 14/05/14).
  • Reisert, J. Sep 1978. Simple and efficient broadband balun. Ham Radio Magazine Sep 1978 p12.